Product Specifications

Worm Gearboxes

This shaft is designed to fit into a worm gearbox and act as an output shaft. You can install it by following these steps:

• Put the keys into the keyways on the shaft.
• Slide the long end of the shaft through the gearbox.
• The long end of the shaft should stick out the other end of the gearbox; slide the washer onto that end.
• Put the snap ring on after the washer (There is a groove at the end of the shaft for the ring to rest inside).

Product		Gearbox Properties
Part Number	Price	Gearbox Series	Gear Ratio	Maximum Strength of Gears	Input Shaft Diameter
TRM4402_0 85Nm 50 Series Worm Gearbox 30:1	$92.50	50	30 : 1	85 N·m	14 mm

Shaft Couplers

If you need to connect this shaft to a motor or another device with a shaft, you can use a shaft coupler:

Product		Physical Properties
Part Number	Price	Inner Diameter	Material	Coupling Rated Torque	Coupling Rated Speed
TRM4325_0 Jaw Coupling Half 25mm Series 24	$6.85	25 mm	Aluminum	611.8 kg·cm	4000 RPM
TRM4329_0 Jaw Coupling Half 25mm Series 38	$7.40	25 mm	Aluminum	3.3 Mg·cm	4000 RPM

Pulleys and Sprockets

If you're using a rotary system that requires a lot of torque, you may be interested in pulleys and sprockets. By using a two pulleys or sprockets of different sizes, you can increase the gear ratio of the system. Pulleys and sprockets can also be used to transmit rotation over a long distance. For more guidance on building a transmission system, visit our Rotary Motion Guide. Here is a list of our 25mm bore pulleys and sprockets:

Product		Physical Properties
Part Number	Price	Inner Diameter	Number of Teeth
TRM4155_0 #40 Chain Sprocket with 25mm Bore and 20 Teeth	$7.00	25 mm	20
TRM4156_0 #40 Chain Sprocket with 25mm Bore and 40 Teeth	$17.50	25 mm	40
TRM4157_0 #40 Chain Sprocket with 25mm Bore and 60 Teeth	$27.00	25 mm	60

Rotary Bearings

Systems with heavy loads or pulley/sprocket assemblies often put a lot of sideways strain on the shaft. In such a system, you can use rotary bearings to protect and support the shaft:

Product		Physical Properties		Mechanical Properties
Part Number	Price	Inner Diameter	Bearing Type	Static Load	Dynamic Load
TRM4506_0 Flanged Rotary Bearing for 25mm Shaft	$5.25	25 mm	Rotary Shaft (Flanged)	7.9 kN	14 kN
TRM4507_0 Pillow Block Rotary Bearing for 25mm Shaft	$5.75	25 mm	Rotary Shaft (Pillow Block)	7.9 kN	14 kN

Documents

• Mechanical Drawings
• Rotary motion Guide