VINT Hub not connecting..

[crwk78]

Hi,

Can you tell me what I’m doing wrong here?

The temperature sensor and VINT hub are connected via USB and visible / functioning in the Phidget software.

But when I debug the attached code, the Phidget is not detected.

Any ideas?

Thanks,

Charlie K

[mparadis]

What kind of temperature sensor is it?

Are you able to see it when you open the Phidget Control Panel?

Your program only checks if the Phidget is attached once- it's possible the "Attached" flag hasn't been set yet in the small time between Open() completing and checking the attached status.

[crwk78]

Hi,

It's a Temperature Phidget TMP1000_0.

Yes, I can see it in the Control Panel.

Even if I set the open time to over 60000ms there is still no connection.

Thanks,

Charlie K

[Patrick]

Your issue is likely using a blocking open call in the GUI load event - this can lead to a deadlock. You should call the non-blocking open() after registering a Phidget attach event, and interact with the Phidget from it's attach event.

-Patrick