Stc1003 issue

Any hardware type questions or problems for all other Phidget devices.
Post Reply
nm17
Phidgeteer!
Posts: 53
Joined: Mon Nov 27, 2017 3:29 am
Contact:

Stc1003 issue

Post by nm17 »

Hi

I have 2 x stc1003 connected to 2 bipolar steppers and to a pc via vint hub and everything worked fine until I switched the set up on today. The steppers started making a singing noise and phidgets control panel can't see STC boards anymore (only another dcc1003 that is hooked up).

I never had anything like this before so unsure if the stc boards or vint hub are dead or if this is symptomatic of another issue. Sadly, I don't have spare boards to test replacing them.

The only change made today was upgrade to latest firmware and phidgets drivers and that worked ok for few hours.

Did anyone experience anything similar? Please help
nm17
Phidgeteer!
Posts: 53
Joined: Mon Nov 27, 2017 3:29 am
Contact:

Re: Stc1003 issue

Post by nm17 »

Resolution (for the benfit of anyone who experiences something similar):

the stepper controller STC1003 has died, most likely one of the ICs on the board.
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests