Hi Dan I have the same issue on DAQ1301 - it intermittently disconnects itself... The Phidgets log doesn't show the "close" of DAQ or any other faults (and I keep the Phidgets log at "verbose" level). My ...
... the duct to clean the panel up. I was surprised because the only other wires in there were 24vdc signal wires, no big power or motor cables etc. Dan
... I will try swapping that unit out with another one. Any thoughts on what else I can check to eliminate this would be greatly appreciated. Thanks, Dan H
To avoid BBQ'ing my Phidgets, does the signal wire from that sensor go to the black, white or red lead on the VINT cable when I connect it to the DAQ1000?
Thanks, Dan
Ooops. I just noticed that the output of the sensor is "0-5volts" in the very first line of it's description. I'll connect it to the DAQ1000 and read it's condition there.
Please correct me if I am going about that wrong.
... input of a 'Versatile Input Phidget', which looks like it only reads <5volts, so am I wrong to try to read this sensor with the DAQ1301? Thanks, Dan Hoskin
... control power unit instead and try that tomorrow. Any other suggestions on what to try to get this thing stable would be most appreciated. Thanks, Dan
... all installed within 2 ft of the control PC, but I went with the Ethernet connection because I assumed it would be more stable than USB. Thanks, Dan
... of my disconnect issues? I'll put an amp meter on the supply with all the motors running and see what I get and post it here shortly. Thoughts? Dan H
