I downloaded the 1.04 buildroot tarball and was able to build it successfully on Ubuntu 10.04 (I could never get version 1.03 to fully build on the same host).
FYI, I also did a very simple test cross-compiling a helloworld.c with a gcc 4.4.3 toolchain I built with crosstool-ng 1.70 (arm-unknown-linux-uclibcgnueabi-gcc) and it seemed to work just fine.
I tried the same test with the free codesourcery arm toolchain but could not get it to work -- I suspect it's because they don't provide a uclibc version.
Thanks for the work in getting this out!
[Edit] PS: one other strange thing-- I had a few binaries compiled with the old OABI toolchain and they still actually ran on the SBC with the new EABI firmware... obviously not a problem, but I don't get it (and I'm positive that I'm running the new firmware).
So I built TemperatureSensor-simple.c from the examples with the old compiler and while it does run on the SBC, the floating point numbers are all wrong... which kind of makes sense since EABI primarily affects floating point calls.
It would probably be better if the old apps just died, but there's not much you can do about it I guess.
hi to everyone, i just wanted to ask why there's a problem upgrading my SBC 1070 with the latest firmware "PhidgetSBC Full (18.104.22.16801103)"???
It doesn't open the webservices in Bonjour tab...So i forced to go back to my previous firmware "phidgetsbc-full_22.214.171.12400129"...
thanx Patric you were right...I want to ask you sth else now...
I have bought from you the 1070 -SBC and the 1203 PhidgetInterfaceKit 8/8/8 and the 1125 Humidity/Temperature sensor.
I'm trying to get access to my interfaces and I cannot...Only through Phidgets manager everything seems to be ok...In an y example I tried with c, i get the known message error timeout for waiting attachment.
CAn you help me on how can i get access???
I saw some of the posts in your forum an d i also tried the "InterfaceKit-simple.c" in VS2010 but nothing new came and with this one...Waht I am doing wrong???
I also checked the "phidget21.h" and in the enum definitions there are neither the 1070-SBC or 1125 sensor defined...only the 1203 interface kit...Is this the problem???