Magnetometer Calibration Spatial1042

Comments & issues
Post Reply
tryouts123
Fresh meat
Posts: 2
Joined: Mon May 22, 2023 4:06 am
Contact:

Magnetometer Calibration Spatial1042

Post by tryouts123 »

Hello,
I've been trying to calibrate the magnetometer on the Phidget Control Panel, so i start, rotate arround the Z axis and stop.
But one I stop, the page close, and I have no parameters.
PCP Version : 1.14.20230331
Phidgets version : 303
jdecoux
Labview Developer
Posts: 161
Joined: Mon Nov 13, 2017 10:20 am
Contact:

Re: Magnetometer Calibration Spatial1042

Post by jdecoux »

I'm having a hard time replicating this issue on this end with the same device, firmware and library versions.

What specifically are you doing to try to calibrate the compass?
tryouts123
Fresh meat
Posts: 2
Joined: Mon May 22, 2023 4:06 am
Contact:

Re: Magnetometer Calibration Spatial1042

Post by tryouts123 »

Version I was using : 1.14.20230331

What I'm doing is going to the magnetometer menu, then to calibrate menu, select 2D axis, and "start" then rotate the phidgets arround it's center. But once i finish the window crashes, and I don't get the parameters.
Somehow the issue resolved itself when i changed my computer.
Post Reply

Who is online

Users browsing this forum: No registered users and 14 guests