Circular Touch hole drilling

Comments & issues
Post Reply
Lincon
Fresh meat
Posts: 4
Joined: Wed Jun 26, 2019 5:10 am

Circular Touch hole drilling

Post by Lincon »

Hello everyone,,,
I have a question regarding the Phidget Circular touch, I know from the looks of the product that you could completely remove the very center of it where there are no components, but there where the 8 areas are for touching, could you drill a small hole in the center of it without destroying it? (1-5mm diameter)

Lincon.
User avatar
mparadis
Site Admin
Posts: 959
Joined: Fri Oct 28, 2011 12:17 pm
Contact:

Re: Circular Touch hole drilling

Post by mparadis »

It should be fine to drill a small hole in the middle of the board where there are no components or touch regions.

(Note: we do not recommend this for higher powered Phidgets e.g. motor controllers)
Post Reply

Who is online

Users browsing this forum: No registered users and 23 guests