phidgets for robot

Technical Discussions on any InterfaceKits
Post Reply
ali khan
Phidgetsian
Posts: 6
Joined: Mon Nov 30, 2015 6:57 am
Contact:

phidgets for robot

Post by ali khan »

hi
i have a phidgets 1018 an ir sensor and 2 servo motors plus and a 1010
i was planning to make a obstacle avoidance robot but found out that i need a motor controller for the servos.
well with that i was thinking to buy an arduino motor shield and so i wanted to ask if it would work with the 1018 interface kit
also can i please have a source code too coz i dont know programming at all
User avatar
mparadis
Site Admin
Posts: 959
Joined: Fri Oct 28, 2011 12:17 pm
Contact:

Re: phidgets for robot

Post by mparadis »

As far as I know, most Arduino servo shields communicate using I2C, and none of the Phidgets InterfaceKits have support for communicating with I2C devices. You'll either have to get a Phidgets servo controller, or get an Arduino and shield.

If you decide to use Phidgets, you can download some servo controller sample code by clicking on "programming" at the top of this page and going to the download section of the language of your choice. However, to make a robot like the one you've described, you will inevitably have to do some programming.
ali khan
Phidgetsian
Posts: 6
Joined: Mon Nov 30, 2015 6:57 am
Contact:

Re: phidgets for robot

Post by ali khan »

so i can control the servos with the 1018

thanks
User avatar
mparadis
Site Admin
Posts: 959
Joined: Fri Oct 28, 2011 12:17 pm
Contact:

Re: phidgets for robot

Post by mparadis »

No, servo motors need a pulse-code modulation signal with very specific pulse widths that the 1018 is incapable of delivering. If you use Phidgets, you'll need to use one of our servo controller boards instead.
Post Reply

Who is online

Users browsing this forum: Semrush [Bot] and 18 guests