Labview stepper example

Supporting Labview 2012 and up
aro
Phidgetly
Posts: 16
Joined: Wed Oct 31, 2012 3:03 pm
Contact:

Labview stepper example

Postby aro » Fri Dec 20, 2013 12:28 pm

I am new to phidgets and am trying to get a stepper working with the 1062 board. It is recognized and moves with the phidget control panel, and the 'attached' led and correct serial number are shown in the example VI when I run. However, when I try to set a new target position, the program behaves as if it is moving but the motor does not move. Any thing i can do to troubleshoot?
Thanks.

aro
Phidgetly
Posts: 16
Joined: Wed Oct 31, 2012 3:03 pm
Contact:

Re: Labview stepper example

Postby aro » Fri Dec 20, 2013 1:14 pm

Never mind, I re-downloaded the examples and it worked this time.


Return to “Labview”

Who is online

Users browsing this forum: No registered users and 3 guests