Lmpacent at 16:42, 15 June 2017

2017-06-15T16:42:22Z

← Older revision		Revision as of 16:42, 15 June 2017
Line 6:		Line 6:
	{{UGExampleDescription}}		{{UGExampleDescription}}
	*Toggle the ''Engage'' button to provide power to the motor coils.		*Toggle the ''Engage'' button to provide power to the motor coils.
	*When the {{{1}}} is no longer issuing commands to the motor, it will update the ''Stoppped?'' checkbox.
	*By default, motor position, velocity, and acceleration are measured in sixteenths of a step. If you want to use different units, change the value in the ''Rescale Factor'' textbox.		*By default, motor position, velocity, and acceleration are measured in sixteenths of a step. If you want to use different units, change the value in the ''Rescale Factor'' textbox.
	*Use the ''Target Position'' slider to set a new target position. Change the ''Acceleration'' and ''Velocity'' sliders to speed up or slow down the {{{1}}}'s approach.		*Use the ''Target Position'' slider to set a new target position. Change the ''Acceleration'' and ''Velocity'' sliders to speed up or slow down the {{{1}}}'s approach.

Lmpacent: Created page with "===Stepper Motor=== Double-click on the Stepper object, labelled ''{{{2}}}'', in order to run the example: link= {{UGExampleDesc..."

2017-06-14T23:56:43Z

Created page with "===Stepper Motor=== Double-click on the Stepper object, labelled ''{{{2}}}'', in order to run the example: [[Image:{{{1}}}_Stepper_Example.jpg|center|link=]] {{UGExampleDesc..."

New page

===Stepper Motor===
Double-click on the Stepper object, labelled ''{{{2}}}'', in order to run the example:
[[Image:{{{1}}}_Stepper_Example.jpg|center|link=]]

{{UGExampleDescription}}
*Toggle the ''Engage'' button to provide power to the motor coils.
*When the {{{1}}} is no longer issuing commands to the motor, it will update the ''Stoppped?'' checkbox.
*By default, motor position, velocity, and acceleration are measured in sixteenths of a step. If you want to use different units, change the value in the ''Rescale Factor'' textbox.
*Use the ''Target Position'' slider to set a new target position. Change the ''Acceleration'' and ''Velocity'' sliders to speed up or slow down the {{{1}}}'s approach.
*Use the ''Current Limit'' slider to change the maximum amount of current supplied to the motor's coils. See your motor's datasheet for the recommended coil current.
*Select the ''Velocity (Continuous) Control'' tab for continuous rotation instead of specifiying a position.
<br clear="all">

Template:UgStepperCurrent - Revision history

Lmpacent at 16:42, 15 June 2017

Lmpacent: Created page with "===Stepper Motor=== Double-click on the Stepper object, labelled ''{{{2}}}'', in order to run the example: link= {{UGExampleDesc..."