Mparadis: Created page with "===Encoder=== link= When you double click on an Encoder object, a window like the one pictured will open. * At the top of the wind..."

2017-05-31T15:38:13Z

Created page with "===Encoder=== right|link= When you double click on an Encoder object, a window like the one pictured will open. * At the top of the wind..."

New page

===Encoder===

[[Image:Encoder_Dial_Example.jpg|right|link=]]

When you double click on an Encoder object, a window like the one pictured will open.

* At the top of the window, information about your device and the properties of this particular channel will be listed.
* On the left, you can enable the input (if applicable) and specify the counts per revolution (CPR) to enable velocity calculation. Press enter after typing a number to enable velocity. You can also adjust the [[Data_Interval/Change_Trigger|Data Interval and Change Trigger]].
* On the right, real-time data is displayed:
** '''Position Change:''' The number of ticks (or quadrature cycles) that have occurred since the last change event.
** '''Time Change:''' The amount of time in milliseconds that has elapsed since the last change event.
** '''Position:''' The total position in ticks relative to where the encoder was when the window was opened.
** '''Index Position:''' Not supported by this device.
** '''Velocity:''' If a CPR has been specified, the average velocity in rotations per minute.

<br clear="all">

Template:UgEncoderDial - Revision history

Mparadis: Created page with "===Encoder=== link= When you double click on an Encoder object, a window like the one pictured will open. * At the top of the wind..."